Come April I will be lifting San Felice out for a scrub. I am looking at changing the bushes on the rudder and wondering how much clearance under the keel I will need to drop and remove the rudder?
Cheers, Brett
Rudder removal
4 posts
• Page 1 of 1
Rudder removal
by Brett2016 » Wed Feb 06, 2019 5:50 pm
- Brett2016
- Posts: 27
- Images: 1
- Joined: Thu Sep 01, 2016 6:02 pm
Re: Rudder removal
by Phillip » Wed Feb 06, 2019 10:59 pm
A minimum of 800mm.
Best to remove inwater if you can and get towed to your haul out place.
Also consider replacing the cutless bearings top and bottom in the rudder tube as any flop in the rudder is caused by these 2 bearings.
Best to remove inwater if you can and get towed to your haul out place.
Also consider replacing the cutless bearings top and bottom in the rudder tube as any flop in the rudder is caused by these 2 bearings.
Phillip.
SEAKA
A 1969 Mark 1
Home port is at Dunbogan on the Camden Haven Inlet, Laurieton NSW
SEAKA
A 1969 Mark 1
Home port is at Dunbogan on the Camden Haven Inlet, Laurieton NSW
-
Phillip - Site Admin
- Posts: 1826
- Images: 152
- Joined: Wed Jan 07, 2009 8:18 pm
- Location: Camden Haven Inlet, Mid-North Coast NSW.
Re: Rudder removal
by Brett2016 » Tue Feb 12, 2019 2:06 pm
Thanks Phillip. Sorry for late reply just got back from Hobart wooden boat festival
- Brett2016
- Posts: 27
- Images: 1
- Joined: Thu Sep 01, 2016 6:02 pm
Re: Rudder removal
by Phillip » Tue Feb 12, 2019 8:50 pm
Brett2016 wrote:Thanks Phillip. Sorry for late reply just got back from Hobart wooden boat festival
Phillip.
SEAKA
A 1969 Mark 1
Home port is at Dunbogan on the Camden Haven Inlet, Laurieton NSW
SEAKA
A 1969 Mark 1
Home port is at Dunbogan on the Camden Haven Inlet, Laurieton NSW
-
Phillip - Site Admin
- Posts: 1826
- Images: 152
- Joined: Wed Jan 07, 2009 8:18 pm
- Location: Camden Haven Inlet, Mid-North Coast NSW.
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 95 guests