Has anyone ever cut an anchor well into a MK1? If so is it a difficult job? I'd really appreciate some info on this. On my previous MK 2 , I found the anchor well worked really well; the prop was always deep in the water, the weight of the motor was well forward, all in all a good arrangement.
Peter Vickerson
Anchor well for MK 1
3 posts
• Page 1 of 1
Re: Anchor well for MK 1
by Phillip » Sun May 10, 2009 11:12 pm
Peter,
I carry my anchor on the bow roller.
Had to set up an extension to the bow roller and a tie down point, but it works very well
.
Phillip
SEAKA
I carry my anchor on the bow roller.
Had to set up an extension to the bow roller and a tie down point, but it works very well
.Phillip
SEAKA
Phillip.
SEAKA
A 1969 Mark 1
Home port is at Dunbogan on the Camden Haven Inlet, Laurieton NSW
SEAKA
A 1969 Mark 1
Home port is at Dunbogan on the Camden Haven Inlet, Laurieton NSW
-
Phillip - Site Admin
- Posts: 1826
- Images: 152
- Joined: Wed Jan 07, 2009 8:18 pm
- Location: Camden Haven Inlet, Mid-North Coast NSW.
Re: Anchor well for MK 1
by Tales » Mon May 11, 2009 5:01 pm
Think he is really asking about a motor well!
Cheers,
Tom
Cheers,
Tom
- Tales
- Posts: 366
- Joined: Mon Feb 09, 2009 2:40 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 261 guests