Replaced tap in sink
Posted: Sat Feb 08, 2014 9:10 amThe old Trojan pump needed replacing so I decided to go for an electric water pump. However, the hole where the old pump went was a bit mangled.
After using masking tape and a bit of wood underneath, I put some epoxy mix into the hole.
Another layer of smooth stuff.
Painted, then carefully drilled out the right size hole.
Tap connected and working fine. Now I can move onto the other zillion jobs needing doing.
- sink1.jpg (235.63 KiB) Viewed 1504 times
After using masking tape and a bit of wood underneath, I put some epoxy mix into the hole.
- sink2.jpg (255.47 KiB) Viewed 1504 times
Another layer of smooth stuff.
- sink3.jpg (314.18 KiB) Viewed 1504 times
Painted, then carefully drilled out the right size hole.
- sink4.jpg (256.29 KiB) Viewed 1504 times
Tap connected and working fine. Now I can move onto the other zillion jobs needing doing.
- sink5.jpg (267.86 KiB) Viewed 1504 times