In the past when my boat was slipped, Fenwicks just did the acid wash of the hull above the antifoul. I did not request this and last week when my boat was slipped, it was not acid washed.
What is the best way (what to use?) to do this in the water?
Hull clean
3 posts
• Page 1 of 1
Hull clean
by Killick69 » Tue Dec 13, 2016 5:06 am
- Killick69
- Posts: 279
- Joined: Tue Aug 10, 2010 4:26 pm
Re: Hull clean
by Phillip » Tue Dec 13, 2016 12:16 pm
I used one from whitworths and after starting a clean up around the water line had to go back and redo the whole hull as I could see he difference very easily.
Phillip.
SEAKA
A 1969 Mark 1
Home port is at Dunbogan on the Camden Haven Inlet, Laurieton NSW
SEAKA
A 1969 Mark 1
Home port is at Dunbogan on the Camden Haven Inlet, Laurieton NSW
-
Phillip - Site Admin
- Posts: 1826
- Images: 152
- Joined: Wed Jan 07, 2009 8:18 pm
- Location: Camden Haven Inlet, Mid-North Coast NSW.
Re: Hull clean
by Sailtime » Tue Dec 13, 2016 1:49 pm
I used oxalic acid.. mix a tablespoon of the crystals in a bucket with water and wipe it on then hose it off after a minute or so, cleans it right up
Not sure how eco friendly it is to use while in the water but it works super well. Wear goggles/gloves cause it's acid!
http://www.totalsupplysolutions.com.au/ ... -brilliant
Not sure how eco friendly it is to use while in the water but it works super well. Wear goggles/gloves cause it's acid!
http://www.totalsupplysolutions.com.au/ ... -brilliant
- Sailtime
- Posts: 78
- Joined: Tue Dec 22, 2015 5:34 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 26 guests